![]() Now try CELTSCALE set to 2 and place a new line on the screen. Draw a line on each layer to view the different line types. ![]() Load the two linetypes using the test.lin file.In a text editor, create a file named test.lin and paste the following text in the file.Ī,1.0,-0.5,-2.0Ī,1.0,-0.5,-3.0.Enter celtscale on the command line, and set the value to 1.Enter ltscale on the command line, and set the value to 1.Accept the defaults for all the other settings.Use the txt.shx font, and set the height to zero.Some fonts adhere to standards which may cause the center to be off. Tip: You may want to place a line of text with mtext first and use the distance command to check the character height. If the S=1, then you will want to offset Y=.5 to center the line. The linetype transform values S= (text height) and Y= (Y offset) are for centering the characters. When you create the complex linetype, you will assign the actual text height for the "S" transform. The following exercise will demonstrate how to create a complex linetype and change the scale proportionally. Use the text style exclusively for the complex linetype.If you change the text style height, any complex linetype using that style is affected.Define the linetype, using the S= for the text height.Create the text STYLE with a height of zero.Unless you follow these rules, it will shift out of alignment with the dashes that you have created. If you plan to use the LTSCALE or CELTSCALE command in the drawing, the text will change to the new size. Note: You will also receive this message if there is not a hard return, or, placed at the end of the file that you have created. Unless the text style used in the linetype has been defined in the current drawing, the following error message (or similar) is displayed when you try to load the line:īad definition of (linetype name) at line (line#) of file c:\Acltwin\filename.lin If you try to create the linetype within the program, the following error message is displayed:īefore you create a linetype with text in it, define the text style that you will use. Note: Use a text editor such as Notepad to create the complex linetype. You must use the REGEN command to see the changes. No other text style settings will apply, unless multiline text is placed in the drawing using the same text style defined in the complex linetype. ![]() ![]() ![]() The text height setting will affect the linetype if it is set to a specific height other than zero (0). Before you create complex linetypes using text, consider how the font settings, scaling, and colors will affect the linetype. Complex linetypes are custom linetypes that can contain embedded shapes or text. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |